Use the same procedure for RHD and LHD vehicles.
The procedures listed below are for RHD vehicles.
1.REMOVE FRONT SEAT ASSEMBLY
73230
2.REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Driver Side)
| *1 | Band |
Disengage the 2 clamps.
Cut the band.
| *1 | Hook and Loop Fastener |
Unfasten the hook and loop fastener and open the front seat cushion cover.
Disengage the clamp.
Remove the bolt, washer and front seat inner belt assembly RH.
73240
3.REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Front Passenger Side)
Disengage the 3 clamps.
Disconnect the connector.
| *1 | Hook and Loop Fastener |
Unfasten the hook and loop fastener and open the front seat cushion cover.
Disengage the clamp.
Remove the bolt, washer and front seat inner belt assembly LH.