Home › Vehicle Interior › SEAT BELT › REAR CENTER SEAT OUTER BELT ASSEMBLY(for Rear No. 1 Seat) › from 2015.08
RM19Y0E _58 Vehicle Interior _003012 SEAT BELT _0195364 REAR CENTER SEAT OUTER BELT ASSEMBLY(for Rear No. 1 Seat) A

SEAT BELT  REAR CENTER SEAT OUTER BELT ASSEMBLY(for Rear No. 1 Seat)  INSTALLATION  


PROCEDURE

Hide 73310D 1.INSTALL REAR SEAT 3 POINT TYPE CENTER BELT ASSEMBLY

a.
B412672C01
1.167,0.354 1.479,0.552 0.313,0.198 10 false *a 0.146,2.75 0.458,2.948 0.313,0.198 10 false *b 0.719,1.552 1.104,1.781 0.385,0.229 10 false 45°
*a Lock
*b Unlock


Check the angle of inclination required to lock the retractor.

i.

Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

NOTICE:

Do not disassemble the retractor.


If the operation is not as specified, replace the rear seat 3 point type center belt assembly.



b.

Engage the 2 guides and Install the 2 bolts.

Torque:
40.5 N*m (413 kgf*cm, 30 ft.*lbf)


c.

Engage the 2 guides.


d.

Install the rear seat 3 point type center belt assembly with the 2 bolts.

Torque:
40.5 N*m (413 kgf*cm, 30 ft.*lbf)


e.

Check that the ELR locks.

NOTICE:

The check should be performed with the rear seat 3 point type center belt assembly installed.


i.

With the belt installed, check that the belt locks when it is pulled out quickly.

If the operation is not as specified, replace the rear seat 3 point type center belt assembly.



Hide 63310 2.INSTALL ROOF HEADLINING ASSEMBLY