84306
1.INSPECT SPIRAL CABLE SUB-ASSEMBLY
If there are any defects as mentioned below, replace the spiral cable sub-assembly with a new one:
Scratches, cracks, dents or chips in the connector or spiral cable sub-assembly.
| *a | Component without harness connected
(Spiral Cable Sub-assembly) |
Check the spiral cable sub-assembly.
Set the spiral cable sub-assembly to the center position.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE>INSTALLATION
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise and measure the resistance according to the value(s) in the table below.
Do not turn the spiral cable sub-assembly by the airbag wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E63-1 (D+) - z5-1 | Always | Below 1 Ω |
| E63-2 (D-) - z5-2 | Always | Below 1 Ω |
| E67-8 (+) - z7-1 | Always | 3 Ω or less |
| E67-9 (IL+2) - z7-2 | Always | 3 Ω or less |
| E67-10 (AU2) - z7-3 | Always | 3 Ω or less |
| E67 - 11 (AU1) - z7-4 | Always | 3 Ω or less |
| E67 -12 (EAU) - z7-5 | Always | 3 Ω or less |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E63-1 (D+) - z5-1 | Always | Below 1 Ω |
| E63-2 (D-) - z5-2 | Always | Below 1 Ω |
| E67-8 (+) - z7-1 | Always | 3 Ω or less |
If the result is not as specified, replace the spiral cable sub-assembly.
After setting the spiral cable sub-assembly to the center position, rotate the spiral cable sub-assembly 2.5 times clockwise. Then, while rotating the spiral cable sub-assembly 5 times counterclockwise, measure the resistance according to the value(s) in the table below.
Do not turn the spiral cable sub-assembly by the airbag wire harness.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E63-1 (D+) - z5-1 | Always | Below 1 Ω |
| E63-2 (D-) - z5-2 | Always | Below 1 Ω |
| E67-8 (+) - z7-1 | Always | 3 Ω or less |
| E67-9 (IL+2) - z7-2 | Always | 3 Ω or less |
| E67-10 (AU2) - z7-3 | Always | 3 Ω or less |
| E67 - 11 (AU1) - z7-4 | Always | 3 Ω or less |
| E67 -12 (EAU) - z7-5 | Always | 3 Ω or less |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| E63-1 (D+) - z5-1 | Always | Below 1 Ω |
| E63-2 (D-) - z5-2 | Always | Below 1 Ω |
| E67-8 (+) - z7-1 | Always | 3 Ω or less |
If the result is not as specified, replace the spiral cable sub-assembly.
As the spiral cable sub-assembly may break, do not rotate the spiral cable sub-assembly more than the specified amount.