Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
87947B
1.REMOVE OUTER REAR VIEW MIRROR LH
| *1 | Protective Tape |
| *2 | Moulding Remover |
Push the upper part of the outer mirror surface and tilt it.
Apply protective tape to the bottom of the outer mirror cover.
Using a moulding remover, disengage the 2 claws.
Disengage the 2 guides to remove the outer rear view mirror LH.
87945
2.REMOVE UPPER OUTER MIRROR COVER LH (w/o Side Turn Signal Light)
87945
3.REMOVE UPPER OUTER MIRROR COVER LH (w/ Side Turn Signal Light)
Use the same procedure as for the upper outer mirror cover LH (w/o Side Turn Signal Light).
87945B
4.REMOVE LOWER OUTER MIRROR COVER LH
81740
5.REMOVE SIDE TURN SIGNAL LIGHT ASSEMBLY LH (w/ Side Turn Signal Light)