The air conditioner pressure sensor is attached to the high-pressure pipe block to detect an abnormal refrigerant pressure. A DTC is stored if abnormal refrigerant pressure is detected.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0530 | A/C Refrigerant Pressure Sensor System Malfunction | Both of the following conditions are met (1 trip detection logic):
·
Refrigerant pressure is less than 0 MPa (0 kgf/cm2) or 3.187 MPa (32 kgf/cm2) or higher. ·
A/C volume switch is active. |
·
Open or short in air conditioner pressure sensor circuit ·
Air conditioner pressure sensor ·
ECM |
- | DTC stored |
| *a | Front view of wire harness connector
(to Air Conditioner Pressure Sensor) |
Disconnect the air conditioner pressure sensor connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A28-3 (VC) - A28-1 (E) | Ignition switch ON | 4.75 to 5.25 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
Disconnect the air conditioner pressure sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-43 (ACAD) - A28-2 (VOUT) | Always | Below 1 Ω |
| A24-43 (ACAD) or A28-2 (VOUT) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the air conditioner pressure sensor.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PRESSURE SENSOR>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Turn the GTS on.
Start the engine.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC P0530 is output | B |
A
B
Disconnect the ECM connector.
Disconnect the air conditioner pressure sensor connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-29 (VCO) - A28-3 (VC) | Always | Below 1 Ω |
| A24-57 (E24) - A28-1 (E) | Always | Below 1 Ω |
| A24-29 (VCO) or A28-3 (VC) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG