Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › SFI SYSTEM › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196149 SFI SYSTEM C

1NR-VE ENGINE CONTROL  SFI SYSTEM  P0603  EEPROM Read/Write Malfunction  


DESCRIPTION

The transponder key ECU assembly ensures security by controlling the START/END of the communication of matching codes with the ECM. It does so in accordance with ignition ON/OFF status and the immobiliser SET/UNSET status. If the communication cannot be matched due to a malfunction in the ECM, a DTC is recorded.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P0603 EEPROM Read/Write Malfunction Rolling codes cannot be overwritten into ECM
(1 trip detection logic)
ECM - DTC stored

WIRING DIAGRAM

A361954E01
0.24,2.75 2.49,3.156 2.25,0.406 10 false Transponder Key ECU Assembly 0.24,2.573 0.76,2.865 0.521,0.292 10 false E58 5.823,2.531 6.344,2.823 0.521,0.292 10 false A24 5.823,2.708 6.344,3 0.521,0.292 10 false ECM 5.677,1.042 6.198,1.333 0.521,0.292 10 false SIO2 1.167,1.042 1.688,1.333 0.521,0.292 10 false SIO2 1.375,1.604 1.635,1.865 0.26,0.26 10 false E 1.583,1.49 1.844,1.75 0.26,0.26 10 false 14 1.594,0.917 1.854,1.177 0.26,0.26 10 false 9 5.406,0.927 5.667,1.188 0.26,0.26 10 false 54

PROCEDURE

1.CHECK DTC OUTPUT
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Clear the DTCs.


e.

Turn the ignition switch off and wait for at least 30 seconds.


f.

Turn the ignition switch to ON.


g.

Turn the GTS on.


h.

Enter the following menus: Powertrain / EFI / Trouble Codes.


i.

Read the DTCs.

HINT:

If P0603 is detected, this indicates that the ECM is malfunctioning. Replace the ECM.



Result:
Result Proceed to
DTCs are not output A
DTC P0603 is output B



A

B