Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › CAMSHAFT POSITION SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196156 CAMSHAFT POSITION SENSOR A

1NR-VE ENGINE CONTROL  CAMSHAFT POSITION SENSOR  INSTALLATION  


PROCEDURE

Hide 11101E 1.INSTALL CAM POSITION SENSOR

a.
A158220

for Exhaust Side

i.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the cam position sensor, be sure to inspect the O-ring.



ii.

Install the cam position sensor to the cylinder head cover sub-assembly with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




iii.

Connect the connector of the cam position sensor.



b.
A158220

for Intake Side

i.

Apply a light coat of engine oil to the O-ring.

NOTICE:

If reusing the cam position sensor, be sure to inspect the O-ring.



ii.

Install the cam position sensor onto the cylinder head cover sub-assembly with the bolt.

Torque:
12 N*m (122 kgf*cm, 9 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the O-ring is not damaged or does not jump out of position during installation.




iii.

Connect the connector of the cam position sensor.