Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › KNOCK SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196160 KNOCK SENSOR A

1NR-VE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

a.
A360050C01
1.688,2.302 2,2.458 0.313,0.156 10 false *a 2.698,3.323 3.01,3.479 0.313,0.156 10 false *b 2.896,3.958 3.208,4.115 0.313,0.156 10 false *c 2.646,4.24 2.958,4.396 0.313,0.156 10 false *c
*a Upper Side
*b 45°
*c 15°


Install the knock control sensor to the cylinder block sub-assembly with the bolt as shown in the illustration.

Torque:
21 N*m (214 kgf*cm, 15 ft.*lbf)

NOTICE:
·

If a component has been dropped or subjected to a strong impact, replace it.

·

Make sure that the knock control sensor is in the correct position.




b.

Connect the knock control sensor connector.