Home › Engine / Hybrid System › 1NR-VE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042271 1NR-VE ENGINE CONTROL _0196161 HEATED OXYGEN SENSOR A

1NR-VE ENGINE CONTROL  HEATED OXYGEN SENSOR  INSTALLATION  


PROCEDURE

Hide 89465 1.INSTALL OXYGEN SENSOR

a.
A360024C01
2.719,0.417 3.031,0.573 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using SST, install the oxygen sensor to the exhaust manifold converter sub-assembly.

SST
09224-00010  

Torque:
Specified tightening torque : 34 N*m (347 kgf*cm, 25 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 29 N*m (296 kgf*cm, 21 ft.*lbf)




b.

Engage the 2 harness clamps and connect the oxygen sensor wire to the radiator pipe sub-assembly.


c.

Connect the oxygen sensor connector.