The ECM and other ECUs are communicate through the CAN communication system. If the ECM cannot communicate with the other ECUs sets a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0129 | Communication with ABS/VSC (Receive) | No communication from skid control ECU (brake actuator assembly) for 2 seconds or more
(1 trip detection logic) |
·
Open or short in skid control ECU (brake actuator assembly) and ECM circuit ·
Skid control ECU (brake actuator assembly) ·
ECM |
Comes on | DTC stored |
| U0142 | Communication with BODY ECU (Receive) | No communication from main body ECU (fuse block assembly) for 1 second or more
(1 trip detection logic) |
·
Open or short in main body ECU (fuse block assembly) and ECM circuit ·
Main body ECU (fuse block assembly) ·
ECM |
Comes on | DTC stored |
| U0151 | Communication with A/B (Receive) | No communication from airbag ECU assembly for 5 seconds or more
(1 trip detection logic) |
·
Open or short in airbag ECU assembly and ECM circuit ·
Airbag ECU assembly ·
ECM |
Comes on | DTC stored |
| U0155 | Communication with Meter (Receive) | No communication from combination meter assembly for 1 second or more
(1 trip detection logic) |
·
Open or short in combination meter assembly and ECM circuit ·
Combination meter assembly ·
ECM |
Comes on | DTC stored |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Turn the GTS on.
Turn the ignition switch to ON and wait for at least 60 seconds.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| U0129, U0142, U0151 or U0155 is output | B |
A
B
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING