51473A
1.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY RH (w/ Heater)
2.DRAIN ENGINE COOLANT (w/ Heater)
17700
3.REMOVE AIR CLEANER ASSEMBLY
| *1 | No. 2 Fuel Vapor Feed Hose |
| *2 | No. 1 Charcoal Canister Hose |
| *3 | No. 1 Vacuum Switching Valve Assembly |
Disconnect the No. 2 fuel vapor feed hose, No. 1 charcoal canister hose and connector from the No. 1 vacuum switching valve assembly.
Disengage the guide and disconnect the No. 2 ventilation hose.
Disconnect the harness clamp from the air cleaner cap sub-assembly.
Disengage the 2 guides and disconnect No. 1 charcoal canister hose from the air cleaner cap sub-assembly (for LHD).
Disconnect the harness clamp and connector from the intake air flow meter assembly.
| *1 | No. 1 Air Cleaner Hose |
| *2 | No. 2 Air Cleaner Hose |
Loosen the 2 hose clamps and disconnect the No. 1 air cleaner hose and No. 2 air cleaner hose.
Remove the 2 bolts and air cleaner assembly.
17881
4.REMOVE NO. 1 AIR CLEANER HOSE
| *1 | No. 2 Ventilation Hose |
Loosen the clip and disconnect the No. 2 ventilation hose.
Loosen the hose clamp and remove the No. 1 air cleaner hose.
16261
5.DISCONNECT NO. 1 WATER BY-PASS HOSE (w/ Heater)
Loosen the clip and disconnect No. 1 water by-pass hose.
16264
6.DISCONNECT NO. 2 WATER BY-PASS HOSE (w/ Heater)
Loosen the clip and disconnect No. 2 water by-pass hose.
22030
7.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY
Disconnect the throttle body with motor assembly connector.
Remove the 3 bolts and the throttle body with motor assembly.
If a component has been dropped or subjected to a strong impact, replace it.
22271A
8.REMOVE THROTTLE BODY GASKET
Remove the throttle body gasket from the intake manifold.