11101E
1.INSTALL CAM POSITION SENSOR
for Exhaust Side
Apply a light coat of engine oil to the O-ring.
If reusing the cam position sensor, be sure to inspect the O-ring.
Install the cam position sensor to the cylinder head cover sub-assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace it.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the connector of the cam position sensor.
for Intake Side
Apply a light coat of engine oil to the O-ring.
If reusing the cam position sensor, be sure to inspect the O-ring.
Install the cam position sensor onto the cylinder head cover sub-assembly with the bolt.
If a component has been dropped or subjected to a strong impact, replace it.
Make sure that the O-ring is not damaged or does not jump out of position during installation.
Connect the connector of the cam position sensor.
2.INSPECT FOR ENGINE OIL LEAK