Prolonged and repeated contact with engine oil will result in the removal of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants which may cause skin cancer.
Wear protective clothing and gloves. Avoid contact with used oil. If contact occurs, wash your skin thoroughly with soap or waterless hand cleaner. Never use gasoline, thinners, or solvents to wash the skin.
In order to protect the environment, dispose of used oil and used oil filters at designated disposal sites only.
12108
1.REMOVE OIL FILLER CAP SUB-ASSEMBLY
Remove the oil filler cap sub-assembly.
51474
2.REMOVE ENGINE SIDE COVER SUB-ASSEMBLY LH
Remove the 2 clips and engine side cover sub-assembly LH.
51443
3.REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)
4.DRAIN ENGINE OIL
Remove the oil pan drain plug and gasket, and drain the engine oil into a container.
Clean and install a new gasket to the oil pan drain plug.
Install the oil pan drain plug.
15601
5.REMOVE OIL FILTER SUB-ASSEMBLY
Using SST, loosen the oil filter sub-assembly, and drain the remaining engine oil from the oil filter sub-assembly.
Set a container below the oil filter sub-assembly before loosening oil filter sub-assembly.
Remove the oil filter sub-assembly.
15601
6.INSTALL OIL FILTER SUB-ASSEMBLY
Apply a small amount of engine oil to the O-ring and temporarily tighten a new oil filter sub-assembly.
Using SST, tighten the oil filter sub-assembly.
7.ADD ENGINE OIL
Add new engine oil.
| Oil Grade | Oil Viscosity (SAE) |
|---|---|
| API grade SN "Resource-Conserving" or ILSAC multigrade engine oil | 0W-20 |
| Item | Standard Condition |
|---|---|
| Drain and refill with oil filter change | 3.5 liters (3.7 US qts, 3.1 Imp. qts) |
| Drain and refill without oil filter change | 3.3 liters (3.5 US qts, 2.9 Imp. qts) |
| Dry fill | 4.0 liters (4.2 US qts, 3.5 Imp. qts) |
12108
8.INSTALL OIL FILLER CAP SUB-ASSEMBLY
Install the oil filler cap sub-assembly.
9.INSPECT FOR ENGINE OIL LEAK
Warm up the engine. Make sure that there are no engine oil leaks from the area that was worked on.
51474
10.INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH
Install the engine side cover sub-assembly LH with the 2 clips.
51443
11.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)