Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196171 CRANKSHAFT POSITION SENSOR A

2NR-VE ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 17750A 1.REMOVE AIR CLEANER INLET ASSEMBLY

Hide 11301K 2.REMOVE CRANK POSITION SENSOR

a.
A353474

Disconnect the crank position sensor connector.


b.

Remove the bolt and the crank position sensor from the timing chain cover sub-assembly.

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.