Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196173 ENGINE COOLANT TEMPERATURE SENSOR A

2NR-VE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422A 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket onto the engine coolant temperature sensor.


b.

Using a 19 mm deep socket wrench, install the engine coolant temperature sensor to the cylinder head sub-assembly.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.



c.

Connect the connector of the engine coolant temperature sensor.


Hide 2.INSTALL ENGINE AND TRANSMISSION ASSEMBLY