Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › HEATED OXYGEN SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196175 HEATED OXYGEN SENSOR A

2NR-VE ENGINE CONTROL  HEATED OXYGEN SENSOR  REMOVAL  


PROCEDURE

Hide 51443 1.REMOVE NO. 2 ENGINE UNDER COVER (w/ Air Fuel Ratio Sensor)

Hide 89465A 2.REMOVE NO. 2 OXYGEN SENSOR (w/ Air Fuel Ratio Sensor)

a.
A363882C01
0,0 0.344,0.354 0.344,0.354 10 false *A 0,2.25 0.344,2.531 0.344,0.281 10 false *B
*A for Manual Transmission
*B for Automatic Transmission


Disengage the 2 harness clamps and disconnect the No. 2 oxygen sensor connector.


b.
A363883N01
1.875,1.615 2.51,1.021 true 1.573,1.615 1.906,1.833 0.333,0.219 10 true SST

Using SST, remove the No. 2 oxygen sensor from the front exhaust pipe assembly.

SST
09224-00010  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.



Hide 89465 3.REMOVE OXYGEN SENSOR (w/o Air Fuel Ratio Sensor)

a.
A360023C01
1.344,1.458 1.021,0.792 true 0.875,0.625 1.188,0.823 0.313,0.198 10 false *1
*1 Radiator Pipe Sub-assembly


Disconnect the oxygen sensor connector.


b.

Disengage the 2 harness clamps and disconnect the oxygen sensor wire from the radiator pipe sub-assembly.


c.
A360025

Using SST, remove the oxygen sensor from the exhaust manifold converter sub-assembly.

SST
09224-00010  

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.