51441
1.REMOVE NO. 1 ENGINE UNDER COVER
16361A
2.REMOVE FAN AND GENERATOR V BELT
13471
3.REMOVE CRANKSHAFT PULLEY
| *a | Hold |
|
Turn |
Using SST, remove the crankshaft pulley bolt.
Never turn the crankshaft pulley counterclockwise (when viewed from the front of the engine).
Remove the crankshaft pulley from the crankshaft.
11302A
4.REMOVE TIMING CHAIN COVER OIL SEAL
| *a | Pry |
| *b | Cut Position |
| *c | Protective Tape |
Using a knife, cut off the timing chain cover oil seal lip.
Using a screwdriver with its tip wrapped with tape, pry out the timing chain cover oil seal.
After removing, check the crankshaft and timing chain cover sub-assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.