Home › Engine / Hybrid System › 1NR-VE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042273 1NR-VE ENGINE MECHANICAL _0196182 REAR CRANKSHAFT OIL SEAL A

1NR-VE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 31250 1.REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

Hide 13405 2.REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)

a.

Using height adjustable attachments and plate lift attachments, place the engine assembly on a flat, level surface.

NOTICE:
·

Using height adjustable attachments and plate lift attachments, place the engine assembly horizontally.

·

To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.

·

Using an engine sling device and engine lift, secure the engine assembly before servicing.




b.
A360083N01
2.344,1.938 2.896,1.854 false 2.958,1.771 3.417,1.969 0.458,0.198 10 false SST

Using SST, hold the crankshaft.

SST
09960-10010  (09962-01000, 09963-01000)

NOTICE:

Never turn the crankshaft pulley counterclockwise (when viewed from the front of the engine).



c.
A360085

Remove the 8 bolts and flywheel sub-assembly.


Hide 3.REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)

Hide 32101 4.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)

a.

Using height adjustable attachments and plate lift attachments, place the engine assembly on a flat,level surface.

NOTICE:
·

Using height adjustable attachments and plate lift attachments, place the engine assembly horizontally.

·

To prevent the oil pan sub-assembly from deforming, do not place any attachments under the oil pan sub-assembly of the engine assembly.

·

Using an engine sling device and engine lift, secure the engine assembly before servicing.




b.
A360083N01
2.344,1.938 2.896,1.854 false 2.958,1.771 3.417,1.969 0.458,0.198 10 false SST

Using SST, hold the crankshaft.

SST
09960-10010  (09962-01000, 09963-01000)

NOTICE:

Never turn the crankshaft pulley counterclockwise (when viewed from the front of the engine).



c.
A360086

Remove the 8 bolts, drive plate and ring gear sub-assembly and centering plate.


Hide 11381A 5.REMOVE REAR ENGINE OIL SEAL

a.
A360087C01
2.469,2.469 1.365,2.115 true 2.542,2.448 2.854,2.646 0.313,0.198 10 false *a 3.135,0.813 3.375,1.021 0.24,0.208 10 false *b
*a Protective Tape
*b Cut Position


Using a screwdriver with its tip wrapped with protective tape, pry out the rear engine oil seal.

NOTICE:

Be careful not to damage the crankshaft bearing.