Home › Engine / Hybrid System › 1NR-VE FUEL › FUEL INJECTOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042275 1NR-VE FUEL _0196201 FUEL INJECTOR A

1NR-VE FUEL  FUEL INJECTOR  INSTALLATION  


PROCEDURE

Hide 23250 1.INSTALL FUEL INJECTOR ASSEMBLY

a.
A158250C05
0.615,1.698 0.615,1.396 false 0.542,1.75 0.729,1.896 0.188,0.146 10 false *1
*1 O-ring


Apply a light coat of spindle oil to new injector vibration insulators and new O-rings, and then install one onto each fuel injector assembly.


b.

Apply a light coat of spindle oil to the contact surfaces of the fuel delivery pipe of the fuel injector assembly.


c.
A296030

While turning the fuel injector assembly left and right, install it onto the fuel delivery pipe.

NOTICE:
·

Do not damage the fuel injector assembly or O-ring.

·

Do not twist the O-ring.

·

After installing each fuel injector assembly, check that it turns smoothly. If not, replace the O-ring with a new one.




Hide 23291 2.INSTALL INJECTOR VIBRATION INSULATOR

a.

Install the 4 new injector vibration insulators and onto the cylinder head sub-assembly.


Hide 23807V 3.INSTALL NO. 1 DELIVERY PIPE SPACER

a.
A359808C01
1.865,0.167 2.021,0.313 0.156,0.146 10 false *a 1.875,0.635 2.021,0.781 0.146,0.146 10 false *b
*a Fuel Delivery Pipe Side
*b Cylinder Head Sub-assembly Side


Install the 2 No. 1 delivery spacers onto the cylinder head sub-assembly.

NOTICE:

Install the No. 1 delivery spacers in the correct direction.



Hide 23814B 4.INSTALL FUEL DELIVERY PIPE

a.

Install the fuel delivery pipe together with the 4 fuel injector assemblies with the 2 bolts.

Torque:
28 N*m (286 kgf*cm, 21 ft.*lbf)

NOTICE:
·

Do not drop the fuel injector assemblies when installing the fuel delivery pipe.

·

After installing the fuel delivery pipe, check that the fuel injector assemblies turn smoothly.




b.

Connect the 4 fuel injector assembly connectors.


Hide 23901 5.CONNECT FUEL TUBE SUB-ASSEMBLY

a.

Connect the fuel tube sub-assembly connector to the fuel delivery pipe until a "click" sound is heard.

NOTICE:
·

Check that there are no scratches or foreign matter on the contact surfaces of the fuel tube connector and fuel delivery pipe before performing this work.

·

After connecting the fuel lines, check that the fuel tube connector and fuel delivery pipe are securely connected by pulling on them.




Hide 23842A 6.INSTALL EFI FUEL PIPE CLAMP

a.

Install the EFI fuel pump clamp.


Hide 17700 7.INSTALL AIR CLEANER ASSEMBLY

Hide 8.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
6.4 N*m (65 kgf*cm, 57 in.*lbf)