1. DISCHARGE FUEL SYSTEM PRESSURE
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
17700
3.REMOVE AIR CLEANER ASSEMBLY
23842A
4.REMOVE EFI FUEL PIPE CLAMP
Remove the EFI fuel pipe clamp.
23901
5.DISCONNECT FUEL TUBE SUB-ASSEMBLY
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel delivery pipe.
23814B
6.REMOVE FUEL DELIVERY PIPE
Make sure that there are no deposits such as sand or grit near the fuel injector assembly, and if there are any deposits, clean them away.
Do not allow foreign matter to enter any other components.
Disconnect the 4 fuel injector assembly connectors.
Remove the 2 bolts and fuel delivery pipe with the 4 fuel injector assemblies.
Do not allow foreign matter to enter the cylinder head sub-assembly.
23807V
7.REMOVE NO. 1 DELIVERY PIPE SPACER
Remove the 2 No. 1 delivery pipe spacers from the cylinder head sub-assembly.
23291
8.REMOVE INJECTOR VIBRATION INSULATOR
Remove the 4 injector vibration insulators.
23250
9.REMOVE FUEL INJECTOR ASSEMBLY
Pull the 4 fuel injector assemblies out of the fuel delivery pipe.
Do not allow foreign matter to enter the fuel delivery pipe.
Remove the O-ring from each fuel injector assembly.
For reinstallation, attach a tag or label with the corresponding cylinder number to each fuel injector assembly shaft.
Protect the fuel injector assemblies by covering them with plastic bags.