Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › AIR FUEL RATIO SENSOR › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196380 AIR FUEL RATIO SENSOR A

2NR-VE ENGINE CONTROL  AIR FUEL RATIO SENSOR  INSTALLATION  


PROCEDURE

Hide 89467B 1.INSTALL AIR FUEL RATIO SENSOR

a.
A360024C01
2.719,0.417 3.031,0.573 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length


Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.

SST
09224-00010  

Torque:
Specified tightening torque : 34 N*m (347 kgf*cm, 25 ft.*lbf)

NOTICE:

If a component has been dropped or subjected to a strong impact, replace it.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 29 N*m (296 kgf*cm, 21 ft.*lbf)




b.

Connect the air fuel ratio sensor connector.


c.

Engage the 2 harness clamps and connect the air fuel ratio sensor wire to the radiator pipe sub-assembly.