If the manual up/down and auto down functions do not operate, a malfunction may exist in the power window regulator master switch assembly, power window regulator motor assembly RH*1 or LH*2 (for front side) or wire harness.
*1: for RHD
*2: for LHD
Remove the power window regulator motor assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW REGULATOR MOTOR(for Front Door)>REMOVAL
Inspect the power window regulator motor assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW REGULATOR MOTOR(for Front Door)>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the F9*1 or G9*2 power window regulator master switch assembly connector.
Disconnect the F8*1 or G8*2 power window regulator motor assembly RH*1 or LH*2 (for front side) connector.
*1: for RHD
*2: for LHD
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F9-11 (DU) - F8-1 (U+) | Always | Below 1 Ω |
| F9-12 (DD) - F8-3 (D+) | Always | Below 1 Ω |
| F9-11 (DU) or F8-1 (U+) - Body ground | Always | 10 kΩ or higher |
| F9-12 (DD) or F8-3 (D+) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G9-14 (DU) - G8-1 (U+) | Always | Below 1 Ω |
| G9-15 (DD) - G8-3 (D+) | Always | Below 1 Ω |
| G9-14 (DU) or G8-1 (U+) - Body ground | Always | 10 kΩ or higher |
| G9-15 (DD) or G8-3 (D+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG