Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003010 SUPPLEMENTAL RESTRAINT SYSTEMS _0015213 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using SST Check Wire)


a.

Check for DTCs (present trouble code).

i.
C198509C03
1.813,1.5 2,1.771 true 1.635,0.885 2.021,0.49 true 1.5,0.146 1.729,0.365 0.229,0.219 10 *a 2.063,1.75 2.5,1.969 0.438,0.219 10 ECUT 2.073,0.417 2.302,0.635 0.229,0.219 10 E
*a Front view of DLC3


Turn the ignition switch to ON and wait for approximately 60 seconds.


ii.

Using SST, connect terminals 13 (ECUT) and 4 (E) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.




b.

Check for DTCs (past trouble code).

i.

Using SST, connect terminals 13 (ECUT) and 4 (E) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the correct terminals to avoid a malfunction.



ii.

Turn the ignition switch to ON and wait for approximately 60 seconds.



c.
C342766E01
0.198,0.063 3.302,0.313 3.104,0.25 10 false Normal System Code (with Past Trouble Code): 0.229,1.646 2.979,1.906 2.75,0.26 10 false Trouble Code (Example Codes 11 and 31): 0.208,0.573 0.521,0.771 0.313,0.198 10 false On 0.208,1.021 0.521,1.219 0.313,0.198 10 false Off 1.063,0.427 1.677,0.688 0.615,0.26 10 false 0.25 sec. 1.188,1.188 1.802,1.448 0.615,0.26 10 false 0.25 sec. 0.063,2.031 0.677,2.292 0.615,0.26 10 false 0.5 sec. 0.156,2.646 0.771,2.906 0.615,0.26 10 false 1.5 sec. 1.01,1.865 1.625,2.125 0.615,0.26 10 false 2.5 sec. 2,1.854 2.615,2.115 0.615,0.26 10 false 4.0 sec. 1.688,2.677 2.302,2.938 0.615,0.26 10 false 0.5 sec. 0.667,3.167 1.281,3.427 0.615,0.26 10 false DTC 11 1.448,3.167 2.063,3.427 0.615,0.26 10 false DTC 31 2.573,2.823 3.188,3.083 0.615,0.26 10 false Repeat

Read the DTCs.

i.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and trouble codes 11 and 31 are shown in the illustration.

·

Normal system code indication (without past trouble code):

The light blinks twice per second.

·

Trouble code indication:

Each digit of a DTC is separated by a 1.5 second pause.


If there is more than 1 code, there is a 2.5 second pause between each code. After all the codes are output, there is a 4.0 second pause, and then all codes are repeated.

HINT:
·

If 2 or more malfunctions are found, the indication begins with the smaller-numbered code.

·

If DTCs are output without connecting the terminals, proceed to "Diagnosis Circuit".

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>Diagnosis Circuit






DTC CLEAR (Using SST Check Wire)


a.

When the ignition switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning off the ignition switch. In this case, proceed to the next step.



b.

Using SST, connect terminals 13 (ECUT) and 4 (E) of the DLC3, and then ignition switch to ON.

SST
09843-18040  


c.

Disconnect terminal ECUT of the DLC3 within 3 to 10 seconds after the DTCs are output and check that the SRS warning light comes on after 3 seconds.


d.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (ECUT) and 4 (E) of the DLC3.


e.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (ECUT) and 4 (E) of the DLC3. Then, disconnect terminal 13 (ECUT) within 2 to 4 seconds after the SRS warning light goes off.


f.

Check that the SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13 (ECUT). Then, reconnect terminals 13 (ECUT) and 4 (E) within 2 to 4 seconds after the SRS warning light comes on.


g.

Check that the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (ECUT) and 4 (E) of the DLC3. Also, check that the normal system code is output within 1 second after the SRS warning light goes off. If DTCs are not cleared, repeat this procedure until the codes are cleared.

E256443E20
0.208,0.406 1.167,0.594 0.958,0.188 10 false Engine Switch 0.031,1.177 1.271,1.365 1.24,0.188 10 false DLC3 (ECUT and E) 0.188,2.146 1.521,2.354 1.333,0.208 10 false SRS Warning Light* 2.719,1.823 3.531,2.031 0.813,0.208 10 false 0.5 seconds 0.219,2.594 1.458,2.771 1.24,0.177 10 false T1: 0 to ∞ seconds 0.219,2.917 2.271,3.125 2.052,0.208 10 false T2: approximately 6 seconds 0.219,3.24 1.427,3.438 1.208,0.198 10 false T3: 3 to 5 seconds 0.219,3.552 1.479,3.76 1.26,0.208 10 false T4: 3 to 10 seconds 0.219,3.875 1.417,4.052 1.198,0.177 10 false T5: 2 to 4 seconds 0.219,4.198 1.406,4.375 1.188,0.177 10 false T6: 1 to 5 seconds 0.219,4.521 1.573,4.708 1.354,0.188 10 false T7: within 1 second 2.333,4.125 6.844,4.365 4.51,0.24 10 false *: The past trouble code in the illustration shows DTC 21 as an example. 2.49,3.479 2.688,3.708 0.198,0.229 10 false T1 5.969,3.479 6.198,3.708 0.229,0.229 10 false T7 4.427,3.479 4.625,3.708 0.198,0.229 10 false T6 4.177,3.479 4.365,3.708 0.188,0.229 10 false T5 3.75,3.479 3.969,3.708 0.219,0.229 10 false T4 3.271,3.479 3.49,3.708 0.219,0.229 10 false T3 2.865,3.479 3.104,3.708 0.24,0.229 10 false T2 4.948,3.479 5.135,3.708 0.188,0.229 10 false T6 4.698,3.479 4.885,3.708 0.188,0.229 10 false T5 5.458,3.479 5.646,3.708 0.188,0.229 10 false T6 5.208,3.479 5.396,3.708 0.188,0.229 10 false T5 5.719,3.479 5.948,3.708 0.229,0.229 10 false T5 1.448,0.396 2.083,0.594 0.635,0.198 10 false ON 1.448,0.823 1.885,1.021 0.438,0.198 10 false OFF 1.365,1.531 2.417,1.719 1.052,0.188 10 false Connected 1.365,1.156 2.281,1.333 0.917,0.177 10 false Disconnected 1.625,2.135 1.885,2.302 0.26,0.167 10 false ON 1.625,2.5 1.948,2.677 0.323,0.177 10 false OFF 3.583,2.802 4.177,3.219 0.594,0.417 10 false 1.5 seconds 3.792,1.813 4.615,2.021 0.823,0.208 10 false 0.5 seconds 5.354,1.76 6.229,1.969 0.875,0.208 10 false 0.25 seconds 6.281,1.75 7.146,1.958 0.865,0.208 10 false 0.25 seconds



CHECK DTC (Using the GTS or Techstream)


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / A/B / Trouble Codes.

Body Electrical > A/B > Trouble Codes
50001 587


CLEAR DTC (Using the GTS or Techstream)


a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Enter the following menus: Body Electrical / A/B / Trouble Codes.


e.

Clear the DTCs.

Body Electrical > A/B > Clear DTCs
50002 587