The transponder key ECU assembly ensures security by controlling the START/END of the communication of matching codes with the ECM. It does so in accordance with ignition ON/OFF status and the immobiliser SET/UNSET status. If the communication cannot be matched due to a malfunction in the ECM, a DTC is recorded.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0603 | EEPROM Read/Write Malfunction | Rolling codes cannot be overwritten into ECM
(1 trip detection logic) |
ECM | - | DTC stored |
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Clear the DTCs.
Turn the ignition switch off and wait for at least 30 seconds.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Powertrain / EFI / Trouble Codes.
Read the DTCs.
If P0603 is detected, this indicates that the ECM is malfunctioning. Replace the ECM.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTC P0603 is output | B |
A
B