Home › Engine / Hybrid System › 2NR-VE ENGINE CONTROL › SFI SYSTEM(w/ Air Fuel Ratio Sensor) › from 2015.08
RM19Y0E _51 Engine / Hybrid System _042272 2NR-VE ENGINE CONTROL _0196262 SFI SYSTEM(w/ Air Fuel Ratio Sensor) C

2NR-VE ENGINE CONTROL  SFI SYSTEM(w/ Air Fuel Ratio Sensor)  U0129  Communication with ABS/VSC (Receive)  U0142  Communication with BODY ECU (Receive)  U0151  Communication with A/B (Receive)  U0155  Communication with Meter (Receive)  


DESCRIPTION

The ECM and other ECUs are communicate through the CAN communication system. If the ECM cannot communicate with the other ECUs sets a DTC.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
U0129 Communication with ABS/VSC (Receive) No communication from skid control ECU (brake actuator assembly) for 2 seconds or more
(1 trip detection logic)
·

Open or short in skid control ECU (brake actuator assembly) and ECM circuit

·

Skid control ECU (brake actuator assembly)

·

ECM


Comes on DTC stored
U0142 Communication with BODY ECU (Receive) No communication from main body ECU (fuse block assembly) for 1 second or more
(1 trip detection logic)
·

Open or short in main body ECU (fuse block assembly) and ECM circuit

·

Main body ECU (fuse block assembly)

·

ECM


Comes on DTC stored
U0151 Communication with A/B (Receive) No communication from airbag ECU assembly for 5 seconds or more
(1 trip detection logic)
·

Open or short in airbag ECU assembly and ECM circuit

·

Airbag ECU assembly

·

ECM


Comes on DTC stored
U0155 Communication with Meter (Receive) No communication from combination meter assembly for 1 second or more
(1 trip detection logic)
·

Open or short in combination meter assembly and ECM circuit

·

Combination meter assembly

·

ECM


Comes on DTC stored

PROCEDURE

1.CHECK WHETHER DTC OUTPUT RECURS
a.

Connect the GTS or Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS or Techstream on.


d.

Clear the DTCs.


e.

Turn the ignition switch off and wait for at least 30 seconds.


f.

Turn the ignition switch to ON.


g.

Turn the GTS or Techstream on.


h.

Turn the ignition switch to ON and wait for at least 60 seconds.


i.

Enter the following menus: Powertrain / EFI / Trouble Codes.


j.

Read the DTCs.


Result:
Result Proceed to
DTCs are not output A
U0129, U0142, U0151 or U0155 is output B



A

B