The Malfunction Indicator Light (MIL) is used to indicate vehicle malfunctions detected by the ECM.
The MIL operation can be checked visually. When the ignition switch is turned to ON, the MIL should be illuminated and should then turn off after engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS or Techstream.
Perform troubleshooting in accordance with the table below.
| Result | Condition | Proceed to |
|---|---|---|
| MIL ON → MIL OFF | Ignition switch ON → Engine is started | A |
| Other than the above | - | B |
A
B
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Check the communication between the GTS or Techstream and ECM.
Checking the Data List for "EFI" is possible.
| Result | Proceed to |
|---|---|
| Communication is possible | A |
| Communication is not possible | B |
A
B
Click hereEngine / Hybrid System>2NR-VE ENGINE CONTROL>SFI SYSTEM(w/ Air Fuel Ratio Sensor)>VC Output Circuit
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: System Select / Health Check.
Check if any DTCs have been detected. Note down any DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Meter / Active Test / Indicator 18 / Engine warning.
Check the status of the MIL while performing the Active Test.
| Result | Proceed to |
|---|---|
| Changes | A |
| Does not change | B |
A
B