FREEZE FRAME DATA
Whenever a meter DTC is detected, the combination meter assembly stores the current vehicle state as freeze frame data.
CHECK FREEZE FRAME DATA
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the GTS or Techstream on.
Enter the following menus: Body Electrical / Combination Meter / Trouble Codes.
According to the GTS or Techstream display, select a DTC that stored freeze frame data.
Read the freeze frame data recorded when the DTC was stored.
| Tester Display | Condition | Displayed Item |
|---|---|---|
| U0073/22 | Control Module Communication Bus Off | ·
Trip ·
Elapsed time after turning the ignition switch ON |
| U0100/51 | Lost Communication with ECM/PCM "A" | |
| U0101/52 | Lost Communication with TCM | |
| U0129/53 | Lost Communication with Brake System Control Module | |
| U0131/66 | Lost Communication with Electric Power Steering ECU | |
| U0142/11 | Lost Communication with Body Control Module "B" | |
| U0151/68 | Lost Communication with Restraints Control Module |
CLEAR FREEZE FRAME DATA
Clearing the DTCs will also clear the freeze frame data.
Connect the GTS or Techstream to the DLC3.
Turn the ignition switch to ON.
Clear DTCs and freeze frame data.
Click hereVehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR