Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › from 2015.08
RM19Y0E _58 Vehicle Interior _003008 METER / GAUGE / DISPLAY _0015206 METER / GAUGE SYSTEM C

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  U0073/22  Communication with CAN  U0100/51  Communication with EFI  U0101/52  Communication with EAT/CVT  U0129/53  Communication with ABS/VSC  U0131/66  Communication with EPS  U0142/11  Communication with ITC  U0151/68  Communication with A/B ECU  


DESCRIPTION

The combination meter assembly communicates with the ECM, skid control ECU (brake actuator assembly), power steering ECU assembly, main body ECU (fuse block assembly), airbag ECU assembly, via the CAN communication system.

DTC No. Detection Item DTC Detection Condition Trouble Area Memory Note
U0073/22 Communication with CAN When bus off is detected more than 1 time.
(1 trip detection logic)
·

CAN communication system

·

Combination meter assembly


DTC is stored -
U0100/51 Communication with EFI No communication from ECM for 1 second or more.
(1 trip detection logic)
·

CAN communication system

·

ECM

·

Combination meter assembly


DTC is stored -
U0101/52 Communication with EAT/CVT No communication from TCM (ECM) for 1 second or more.
(1 trip detection logic)
·

CAN communication system

·

ECM

·

Combination meter assembly


DTC is stored -
U0129/53 Communication with ABS/VSC No communication from skid control ECU (brake actuator assembly) for 1 second or more.
(1 trip detection logic)
·

CAN communication system

·

Skid control ECU (Brake actuator assembly)

·

Combination meter assembly


DTC is stored -
U0131/66 Communication with EPS No communication from power steering ECU assembly for 2 seconds or more.
(1 trip detection logic)
·

CAN communication system

·

Power steering ECU assembly

·

Combination meter assembly


DTC is stored -
U0142/11 Communication with ITC No communication from main body ECU (fuse block assembly) for 1.4 seconds or more.
(1 trip detection logic)
·

CAN communication system

·

Main body ECU (fuse block assembly)

·

Combination meter assembly


DTC is stored -
U0151/68 Communication with A/B ECU No communication from airbag ECU assembly for 5 seconds or more.
(1 trip detection logic)
·

CAN communication system

·

Airbag ECU assembly

·

Combination meter assembly


DTC is stored -

PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if CAN communication DTCs are output.

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM


Result:
Result Proceed to
CAN communication DTCs are output. A
CAN communication DTCs are not output. B



A

B