Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2015.08
RM19Y0E _55 Steering _002997 POWER ASSIST SYSTEMS _0015160 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1557/57  Overheat Preventive Control Current Limit History  


DESCRIPTION

With its built-in temperature sensor, the power steering ECU monitors the power steering ECU assembly and the motor conditions to prevent them from overheating. If the power steering ECU assembly or the motor overheats in cases such as when the steering wheel is kept at either full lock position for a long time with the vehicle stopped, the power steering ECU assembly will reduce the amount of motor current to protect the motor and the power steering ECU assembly against overheating.

HINT:

This code is memorized to record that the motor was protected from thermal overload. Even when this code is displayed, this does not indicate an abnormality.


DTC No. Detection Item DTC Detection Condition Trouble Area Warning Indicate Return-to-normal Condition Note
C1557/57 Overheat Preventive Control Current Limit History
·

When the power steering motor temperature exceeds a predetermined value

·

When the temperature of the power steering ECU exceeds a predetermined value


·

Power steering column assembly

·

Power steering ECU Assembly


Comes on (yellow) Overheart preventive control released Buzzer :
Sounds once

PROCEDURE

1.CONFIRM DTC
a.

Clear the DTCs

Chassis > EPS > Clear DTCs
50002 581

b.

Check for DTCs

Chassis > EPS > Trouble Codes
50001 581
Result:
Result Proceed to
DTC is not output A
C1557/57 is output B
DTC C1557/57 and other DTCs are output C




A

END

B

REPLACE STEERING COLUMN ASSEMBLY

C