Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0192556 AUTOMATIC TRANSMISSION SYSTEM D

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  DIAGNOSIS SYSTEM  


DIAGNOSIS SYSTEM


a.

The automatic transmission has built-in diagnostic functions. If a malfunction occurs in the system, the ECM stores the trouble code in the memory and the AT indicator light blinks (MIL illuminates for almost all codes) to inform the driver. The DTC stored in the memory can be read out by the following procedure.

HINT:

When the diagnosis trouble code is displayed, it is necessary to check whether the malfunction is only in the past or still continuing, and then check the relation to the reproduced malfunction. For this reason, it is required to display the diagnosis code twice, before and after the malfunction symptom check.



b.

To check the DTCs, connect the GTS or Techstream to the DLC3 on the vehicle or read the DTC which is indicated in the combination meter when the ECUT and E terminals on the DLC3 are connected. The GTS or Techstream also enables you to clear the DTCs (for operating instructions, see its instruction book).



2-TRIP DETECTION LOGIC


a.

When a malfunction is first detected, the malfunction is temporarily stored in the ECM memory (1st trip). If the ignition switch is turned off and then turned on again, and the same malfunction is detected again, the MIL illuminates and AT indicator light blinks.



FREEZE FRAME DATA


a.

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not and whether the air/fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.




CHECK BATTERY VOLTAGE


Standard voltage:

11 to 14 V


a.

If the voltage is below 11 V, replace the battery before proceeding.



CHECK MIL


a.

The MIL comes on when the ignition switch is tuned to ON and the engine is not running.

i.

Turn the ignition switch to ON.

HINT:

if the MIL does not light up, troubleshoot the combination meter (Click here Drivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>DIAGNOSIS SYSTEM).



ii.

When the engine is started, the MIL should go off. If the lamp remains on, it means that the diagnosis system has detected a malfunction or abnormality in the system.