Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSMISSION SYSTEM › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0192556 AUTOMATIC TRANSMISSION SYSTEM U

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSMISSION SYSTEM  DATA LIST / ACTIVE TEST  


DATA LIST


HINT:

Using the Data List displayed by the GTS or Techstream, you can read the values of the switches, sensors, actuators and so on without parts removal. Reading the Data List as the first step of troubleshooting is one method of shortening labor time.


NOTICE:

In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the GTS or Techstream to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS or Techstream on.


f.

Enter the following menus: Powertrain / A/T / Data List.


g.

In accordance with the display on the GTS or Techstream, read the Data List.

Powertrain > A/T > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Engine Speed Engine speed Min.: 0 rpm
Max.: 25599.6 rpm
650 to 750 rpm: idle after engine warmed-up -
SPD(NT) Input turbine speed Min.: 0 rpm
Max.: 25599.6 rpm
·

Lock-up ON (After warming up the engine): Input turbine speed equal to the engine speed.

·

Lock-up OFF (Idling at shift lever in N): Input turbine speed nearly equal to the engine speed.


-
SPD(NO) Output shaft speed Min.: 0 rpm
Max.: 25599.6 rpm
3rd when the shift lever in D (After warming up the engine): Output shaft speed becomes close to the input turbine speed -
Vehicle Speed Vehicle speed Min.: 0 km/h (0 mph)
Max.: 255 km/h (158 mph)
Same as speedometer indication -
Accelerator pedal position Accelerator pedal position Min.: 0%
Max.: 100.0%
·

0 %: Accelerator pedal fully released

·

Actual accelerator pedal position


-
Throttle position Throttle position (TP) Min.: 0%
Max.: 100.0%
·

0 to 5 %: Throttle fully closed

·

95 to 100 %: Throttle fully open


-
Battery Voltage Battery voltage Min.: 0 V
Max.: 65.535 V
Idling: 11 to 14 V -
Stop Light Switch Stop light SW status ON / OFF
·

Brake pedal is depressed: ON

·

Brake pedal is released: OFF


-
A/T Oil Temperature 1 ATF Temperature sensor value Min.: -40°C (-40°F)
Max.: 215 °C (419 °F)
·

After Stall Test; Approximately 80 to 100°C(176 to 212°F)

·

Equal to ambient temperature when the engine is cold


If the value is "-40°C (-40°F)" or "215°C (419°F)", ATF temperature sensor circuit is opened or shorted.
SL1 Solenoid Status Shift solenoid SL1 status Min.: 0 mA
Max.: 2550 mA
Shift solenoid valve SL1 is:
ON → OFF: 1000 → 0 mA *1
-
SL2 Solenoid Status Shift solenoid SL2 status Min.: 0 mA
Max.: 2550 mA
Shift solenoid valve SL2 is:
ON → OFF: 1000 → 0 mA *1
-
SL3 Solenoid Status Shift solenoid SL3 status Min.: 0 mA
Max.: 2550 mA
Shift solenoid valve SL3 is:
ON → OFF: 1000 → 0 mA *1
-
Lock Up Solenoid Status Shift solenoid DSL status ON / OFF
·

Shift solenoid DSL: ON

·

Shift solenoid DSL: OFF


-
SOL4 current Line pressure control solenoid assembly status Min.: 0 mA
Max.: 2550 mA
Line pressure control solenoid assembly is:
ON → OFF: 1000 → 0 mA *1
-
SOL5 current Lock up control solenoid assembly status Min.: 0 mA
Max.: 2550 mA
Lock up control solenoid assembly is:
ON → OFF: 1000 → 0 mA *1
-
Shift SW Status(P) Park/neutral position switch status ON / OFF ON: Shift lever in P
OFF: Shift lever not in P
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Shift SW Status(R) Park/neutral position switch status ON / OFF ON: Shift lever in R
OFF: Shift lever not in R
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Shift SW Status(N) Park/neutral position switch status ON / OFF ON: Shift lever in N
OFF: Shift lever not in N
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Shift SW Status(D) Park/neutral position switch status ON / OFF ON: Shift lever in D
OFF: Shift lever not in D
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Shift SW Status(3) Park/neutral position switch status ON / OFF ON: Shift lever in 3
OFF: Shift lever not in 3
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Shift SW Status(2) Park/neutral position switch status ON / OFF ON: Shift lever in 2
OFF: Shift lever not in 2
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Shift SW Status(L) Park/neutral position switch status ON / OFF ON: Shift lever in L
OFF: Shift lever not in L
When the shift lever position displayed on the GTS differs from the actual position, adjustment of the PNP switch, transmission control switch or the shift cable may be incorrect.
(*2)
Sports Shift Up SW - - - The monitor is not available on the vehicle.
Sports Shift Down SW - - - The monitor is not available on the vehicle.
Steer mode selection SW - - - The monitor is not available on the vehicle.
Overdrive Cut Switch #2 - - - The monitor is not available on the vehicle.
Shift Status ECM gearshift command N, 1st, 2nd, 3rd, 4th or R Shift lever in:
·

N: Neutral

·

R: Reverse

·

L: 1st

·

2: 1st or 2nd

·

3: 1st, 2nd or 3rd

·

D : 1st, 2nd, 3rd or 4th


-
Lock Up - - - The monitor is not available on the vehicle.
# Codes(Include History) Number of codes Min.: 0
Max.: 255
- -
HINT:
·

*1: The value may exceed 1000 mA due to the current feedback.

·

*2: When the failure still occurs even after adjusting these parts.

Click hereDrivetrain>A4R AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSMISSION SYSTEM>P0705





ACTIVE TEST


HINT:

Performing the Active Test using the GTS or Techstream allows the relay, VSV, actuator and so on to operate without parts removal. Performing the Active Test as the first step of troubleshooting is one method to shorten labor time.

It is possible to display the Data List during the Active Test.


a.

Warm up the engine.


b.

Turn the ignition switch off.


c.

Connect the GTS or Techstream to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS or Techstream on.


f.

Enter the following menus: Powertrain / A/T / Active Test.


g.

In accordance with the display on the GTS or Techstream, perform the Active Test.

Powertrain > A/T > Active Test
Tester Display Control Range Inspection Item Diagnostic Note
Control the SL1 Solenoid Possible to check the SL1 operation. Operate the shift solenoid valve SL1. [Vehicle Condition]
·

Ignition switch ON

·

Shift lever in P

·

Vehicle stopped

·

Engine stopped

·

Throttle fully closed


Control the SL2 Solenoid Possible to check the SL1 operation. Operate the shift solenoid valve SL2. [Vehicle Condition]
·

Ignition switch ON

·

Shift lever in P

·

Vehicle stopped

·

Engine stopped

·

Throttle fully closed


Control the SL3 Solenoid Possible to check the SL3 operation. Operate the shift solenoid valve SL3. [Vehicle Condition]
·

Ignition switch ON

·

Shift lever in P

·

Vehicle stopped

·

Engine stopped

·

Throttle fully closed


SLT solenoid Possible to check the SLT operation. Operate the line pressure control solenoid assembly. [Vehicle Condition]
·

Ignition switch ON

·

Shift lever in P

·

Vehicle stopped

·

Engine stopped

·

Throttle fully closed


SLU solenoid Possible to check the SLU operation. Operate the lock up control solenoid assembly. [Vehicle Condition]
·

Ignition switch ON

·

Shift lever in P

·

Vehicle stopped

·

Engine stopped

·

Throttle fully closed


SL solenoid Possible to check the SL operation. Operate the shift solenoid valve DSL. [Vehicle Condition]
·

Ignition switch ON

·

Shift lever in P

·

Vehicle stopped

·

Engine stopped

·

Throttle fully closed