Home › Drivetrain › A4R AUTOMATIC TRANSMISSION / TRANSAXLE › VALVE BODY ASSEMBLY › from 2015.08
RM19Y0E _52 Drivetrain _041457 A4R AUTOMATIC TRANSMISSION / TRANSAXLE _0197963 VALVE BODY ASSEMBLY A

A4R AUTOMATIC TRANSMISSION / TRANSAXLE  VALVE BODY ASSEMBLY  REMOVAL  


PROCEDURE

Hide 51443 1.REMOVE NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)

Hide 2.DRAIN AUTOMATIC TRANSMISSION FLUID

a.

Remove the drain plug and gasket, and drain the ATF.


b.

Install the drain plug with a new gasket.

Torque:
29.5 N*m (301 kgf*cm, 22 ft.*lbf)


Hide 51202D 3.REMOVE FRONT LOWER SUSPENSION CROSSMEMBER SUB-ASSEMBLY

Hide 35103 4.REMOVE TRANSMISSION OIL LEVEL DIPSTICK SUB-ASSEMBLY

Hide 35106 5.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

C331386

NOTICE:

Some fluid will remain in the automatic transmission oil pan sub-assembly. Remove all automatic transmission oil pan sub-assembly bolts, and carefully remove the automatic transmission oil pan sub-assembly.


a.

Remove the 18 bolts, automatic transmission oil pan sub-assembly and oil pan gasket.


Hide 33449B 6.REMOVE TRANSMISSION MAGNET

a.

Remove the transmission magnet, and use it to collect steel particles.


b.
C153896

Carefully look at the foreign matter and particles in the automatic transmission oil pan sub-assembly and on the transmission magnet to anticipate the type of wear which might be found in the transmission.

Result:
Steel (magnetic):

bearing, gear and clutch plate wear

Brass (non-magnetic):

bushing wear



Hide 35303 7.REMOVE OIL STRAINER SUB-ASSEMBLY

a.
C314993

Disconnect the 3 claws to remove the oil strainer sub-assembly.

NOTICE:

The oil strainer sub-assembly has 3 claws. Be careful not to break or bend them during removal.


HINT:

Be sure to check whether the oil strainer sub-assembly mesh is clean.



b.
C331388

Remove the O-ring.


Hide 35409D 8.REMOVE MANUAL DETENT SPRING SUB-ASSEMBLY

a.
C331390

Remove the bolt and manual detent spring sub-assembly.


Hide 35410 9.REMOVE TRANSMISSION VALVE BODY ASSEMBLY

a.
C314989

Disconnect the 6 connectors.


b.
C314990C01
0.167,1.917 0.375,1.74 true 0.052,1.938 0.281,2.167 0.229,0.229 10 false *1
*1 ATF Temperature Sensor


Remove the bolt and separate the ATF temperature sensor.


c.
C325147C01
2.99,1.26 3.156,1.073 false 3.188,0.938 3.406,1.156 0.219,0.219 10 false *1
*1 Manual Valve


Uniformly loosen the 6 bolts and remove the transmission valve body assembly.

NOTICE:

Make sure not to drop the manual valve.



Hide 35824 10.REMOVE BRAKE CYLINDER SEAL

a.
C153902C01
1.448,0.594 1.979,0.573 true 2.021,0.5 2.479,0.927 0.458,0.427 10 *1
*1 Brake Cylinder Seal


Remove the brake cylinder seal.