Home › Drivetrain › M5S MANUAL TRANSMISSION / TRANSAXLE › BACK-UP LIGHT SWITCH › from 2015.08
RM19Y0E _52 Drivetrain _002985 M5S MANUAL TRANSMISSION / TRANSAXLE _0015111 BACK-UP LIGHT SWITCH A

M5S MANUAL TRANSMISSION / TRANSAXLE  BACK-UP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84210 1.INSTALL BACK-UP LIGHT SWITCH ASSEMBLY

a.
C321937C02
1.302,2.396 1.771,3.146 true 1.094,1.177 1.406,1.375 0.313,0.198 10 false *a 1.969,1.615 2.281,1.792 0.313,0.177 10 true *b 1.802,3.167 2.24,3.354 0.438,0.188 10 true SST
*a SST Fulcrum Length
*b Torque Wrench Fulcrum Length


Using SST, install the back-up light switch assembly and a new gasket to the manual transmission case.

SST
09224-00011  

Torque:
Specified tightening torque : 32 N*m (326 kgf*cm, 24 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a union nut wrench (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 180 mm (7.09 in.)): 27.4 N*m (279 kgf*cm, 20 ft.*lbf)




b.

Connect the back-up light switch connector to the wire bracket.