Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › PROPELLER SHAFT ASSEMBLY › from 2015.08
RM19Y0E _52 Drivetrain _002986 DRIVE SHAFT / PROPELLER SHAFT _0015113 PROPELLER SHAFT ASSEMBLY A

DRIVE SHAFT / PROPELLER SHAFT  PROPELLER SHAFT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 37110 1.TEMPORARILY TIGHTEN PROPELLER SHAFT ASSEMBLY

a.

Insert the propeller shaft assembly into the extension housing.

NOTICE:

Be careful not to damage the oil seal.



b.

Temporarily tighten the center support bearing bracket with the 4 bolts.


c.

Completely remove any oil or the like and clean the contact surfaces of the propeller shaft flange and differential flange.


d.

Align the matchmarks on the propeller shaft and differential flange.


e.

Connect the propeller shaft and differential flange with the 4 bolts and 4 washers.

Torque:
60 N*m (612 kgf*cm, 44 ft.*lbf)


Hide 37110 2.FULLY TIGHTEN PROPELLER SHAFT ASSEMBLY

a.

Lift the rear axle housing up with a jack and apply load to the suspension.


b.
C331479C01
1.615,1 2.01,0.708 true 2.01,0.552 2.281,0.76 0.271,0.208 10 false *a
*a 90°


Check if the center line of the center support bearing bracket makes a right angle with the propeller shaft.


c.

Fully tighten the 4 bolts.

Torque:
37 N*m (377 kgf*cm, 27 ft.*lbf)


d.

Install the cable clamp with the bolt.

Torque:
18 N*m (184 kgf*cm, 13 ft.*lbf)


Hide 3.ADD MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 4.INSPECT MANUAL TRANSMISSION OIL (for Manual Transmission)

Hide 5.ADD AUTOMATIC TRANSMISSION FLUID (for Automatic Transmission)

Hide 6.INSPECT AUTOMATIC TRANSMISSION FLUID LEVEL (for Automatic Transmission)

Hide 7.INSPECT FOR OIL LEAK

Hide 51443 8.INSTALL NO. 2 ENGINE UNDER COVER (w/ No. 2 Engine Under Cover)