Home › Vehicle Interior › DOOR LOCK › DOOR CONTROL TRANSMITTER(for Key Type) › from 2015.08
RM19Y0E _58 Vehicle Interior _003005 DOOR LOCK _0199110 DOOR CONTROL TRANSMITTER(for Key Type) G

DOOR LOCK  DOOR CONTROL TRANSMITTER(for Key Type)  INSPECTION  


PROCEDURE

Hide 89071B 1.INSPECT DOOR CONTROL TRANSMITTER SUB-ASSEMBLY

a.

Check the operation.


ii.
B414233

Install a new or known good transmitter battery.

Click hereVehicle Interior>DOOR LOCK>TRANSMITTER BATTERY(for Key Type)>REPLACEMENT

HINT:

If a new or known good transmitter battery is not available, first connect 2 new 1.5 V batteries in series. Then connect leads to the batteries and apply 3 V to the door control transmitter sub-assembly, as shown in the illustration.



iii.

From outside the vehicle, approximately 1 m (3.28 ft.) from the driver door outside door handle, test the door control transmitter sub-assembly by pointing its key plate at the vehicle and pressing an door control transmitter sub-assembly switch.

OK:

The door lock can be operated via the door control transmitter sub-assembly.

The LED comes on more than once.


·

The operational area differs depending on the user, the way the door control transmitter sub-assembly is held, and the location.

·

The weak radio waves of the door control transmitter sub-assembly may be affected if the area has strong radio waves or noise. The door control transmitter sub-assembly operation area may be shortened or the door control transmitter sub-assembly may not function.




b.

Check the transmitter battery capacity.

i.

Remove the transmitter battery that does not operate. Attach a lead wire (0.6 mm (0.0236 in.) in diameter or less including wire sheath) with tape or equivalent to the negative terminal.

Click hereVehicle Interior>DOOR LOCK>TRANSMITTER BATTERY(for Key Type)>REPLACEMENT

NOTICE:

Do not wrap the lead wire around a terminal, wedge it between the terminals, or solder it. A terminal may be deformed or damaged, and the transmitter battery will not be able to be installed correctly.



ii.
B414234

Carefully pull the lead wire out from the position shown in the illustration and install the previously removed transmitter battery.

Click hereVehicle Interior>DOOR LOCK>TRANSMITTER BATTERY(for Key Type)>REPLACEMENT


iii.
B414235

Check the transmitter battery voltage.

HINT:

Measure the transmitter battery voltage while pressing the lock or unlock switch on the electrical key transmitter sub-assembly.


Standard Voltage:
Tester Connection Condition Specified Condition
Transmitter battery positive (+) - Transmitter battery negative (-) Ignition switch off, all doors closed and lock or unlock switch is pressed 2.5 to 3.2 V


If the result is not as specified, replace the transmitter battery.