FAIL SAFE OPERATION
If there is a problem with sensor signals or actuator systems, the skid control ECU prohibits power supply to the brake actuator assembly and informs the ECM of a VSC system malfunction.
The brake actuator assembly turns off the solenoids and the ECM stops its VSC control according to signals from the skid control ECU. The vehicle will operate in a manner similar to a vehicle that is not equipped with ABS, TRC, VSC and brake hold systems.
ABS control will be prohibited, but EBD control will continue to the extent that EBD control is possible. If EBD control is impossible, the brake system warning light will come on to warn the driver.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSIS SYSTEM
If a VSC system component malfunctions before VSC control begins, VSC control will be prohibited. If a system component malfunctions during VSC control, the system will gradually stop performing control so as not to trigger a sudden change in vehicle operation.
If it is impossible for control to continue, the warning light comes on to inform the driver of system control termination.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DIAGNOSIS SYSTEM
| Malfunction Area | Control Method |
|---|---|
| ABS system | ABS, BA, TRC and VSC control prohibited
Brake hold control prohibited |
| BA system | ABS, BA, TRC and VSC control prohibited
Brake hold control prohibited |
| EBD system | ABS, EBD, BA, TRC and VSC control prohibited
Brake hold control prohibited |
| Malfunction Area | Control Method |
|---|---|
| Engine control system
(TRC system) |
Before control: Disables control
During control: Uses only the brakes to perform control |
| Brake control system
(VSC system) |
Before control: Disables control
During control: Uses only the engine to perform control |
| Brake control system
(TRC system) |
Before control: Disables control
During control: Disables control (by gradually ending control) |