DESCRIPTION
When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the skid control ECU (brake actuator assembly).
The skid control ECU (brake actuator assembly) records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.
To check the DTCs, connect the GTS to the DLC3 of the vehicle. The GTS enables you to clear the DTCs, activate various actuators, and check the freeze frame data and Data List.
Check the battery voltage.
11 to 14 V
If the voltage is below 11 V, recharge the battery before proceeding to the next step.
DIAGNOSIS
If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning light and brake warning light will come on in order to warn the driver.
| *a | Front view of DLC3 |
DTCs are simultaneously stored in memory. Output DTCs can be read by connecting SST to terminals 13 (ECUT) and 4 (E) of the DLC3 and observing the blinking pattern of the ABS warning light or by connecting the GTS.
(See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR)
This system has a test mode (signal check) function.
(See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>TEST MODE PROCEDURE)
WARNING LIGHT INITIAL CHECK
Check that the ABS warning light, VSC OFF indicator light, brake system warning light and slip indicator light illuminate, and then turn off after approximately 3 seconds.
When the brake fluid level is low, the brake system warning light comes on.
If a light does not illuminate, check the communication line between the combination meter assembly and skid control ECU (brake actuator assembly).