The skid control ECU (brake actuator assembly) receives the signals from the ECM, steering angle sensor (spiral cable with sensor sub-assembly) and yaw rate and acceleration sensor (airbag ECU assembly) via the CAN communication system.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| C1207/73 | Shift Signal (Reverse) | With ignition switch ON, communication error continues. | ·
CAN communication system ·
ECM |
- |
| U0073/79 | Abnormal Communication with CAN | Bus offline occurs after 1 second or more elapsed since ignition switch has turned to ON. | CAN communication system | - |
| U0100/49 | Abnormal Communication with EFI | With ignition switch ON, communication error continues. | ·
CAN communication system ·
ECM |
- |
| U0126/19 | Abnormal Communication with Steering Sensor | With ignition switch ON, communication error continues. | ·
CAN communication system ·
Steering sensor (switch base) |
- |
| U0155/75 | Abnormal Communication with Meter | With ignition switch ON, communication error continues. | ·
CAN communication system ·
Combination meter assembly |
- |
Clear the DTC.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
Check if the same DTC is output.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is not output. | A |
| DTC is output. | B |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING