Initialization can be confirmed through the tire pressure warning light.
The order in which the data is received is random.
If the signals from all the wheels are received, initialization is completed.
Initialization is completed when the Data List "ID Tire Inflation Pressure" display shows the correct pressures.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
Initialization is normally completed within a few minutes.
It may take up to a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25.
Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21
If initialization has not been completed successfully, DTC C2177/77 is stored after a vehicle speed of 40 km/h (25 mph) or more continues for 20 minutes or more.
During test mode (sensor check mode), the system will not change to initialization mode even if the tire pressure warning reset switch is pushed.
| *a | Front view of DLC3 |
Initialization can be terminated by connecting terminals 13 (ECUT) and 4 (E) of the DLC3.
BEFORE INITIALIZATION
Make sure that the tires are cold.
Set the air pressure of all tires to the specified value(s).
Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION
INITIALIZATION PROCEDURE
Turn the ignition switch ON.
Press and hold the tire pressure warning reset switch for 3 seconds or more so that the tire pressure warning light blinks 3 times.
| *1 | Tire Pressure Warning Light | *2 | Tire Pressure Warning Reset Switch |
| *a | Tire Pressure Warning Light Output Pattern | *b | 1 sec. |
| *c | ON | *d | OFF |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch ON and turn the GTS on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| ID1 Tire Inflation Pressure | ID1 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If N/A is displayed, data has not been received.*1 |
| ID2 Tire Inflation Pressure | ID2 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If N/A is displayed,data has not been received.*1 |
| ID3 Tire Inflation Pressure | ID3 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If N/A is displayed,data has not been received.*1 |
| ID4 Tire Inflation Pressure | ID4 tire inflation pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi) |
Actual tire inflation pressure | If N/A is displayed,data has not been received.*1 |
| ID5 Tire Inflation Pressure | ID5 tire Inflation Pressure | min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/ cm2, 55 psi) |
Actual tire inflation pressure | If N/A is displayed, data has not been received.*1 |
*1: It may take a few minutes until the values are displayed.
The wheel position cannot be determined from ID1 through ID5 on the Data List.
Check that initialization has been completed.
Confirm that the tire pressure data of all tires is displayed on the GTS screen.