Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.09
RM19Y0E _53 Suspension _059025 TIRE PRESSURE MONITORING _0288381 TIRE PRESSURE WARNING SYSTEM D

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  TEST MODE PROCEDURE  


TEST MODE (SIGNAL CHECK MODE) PROCEDURE


HINT:
·

When entering test mode (signal check mode), the tire pressure warning ECU and receiver sets all the test mode (signal check mode) DTCs first.

After the tire pressure warning ECU and receiver completes the signal check for each inspection item, the DTCs for systems that are determined to be normal will be cleared.

The DTCs for other inspection items may not be cleared when only a certain signal is inspected.

·

When test mode (signal check mode) returns to normal mode, all the test mode (signal check mode) DTCs will be cleared.

·

Operation of the tire pressure warning reset switch can be checked in test mode (signal check mode).

·

During test mode (signal check mode), the system is not initialized by pushing the tire pressure warning reset switch. The circuit of the tire pressure warning reset switch can be inspected during this mode.



a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch ON and the GTS on.


d.
F100632C05
0.979,0.469 1.781,0.646 0.802,0.177 10 false *a 0.677,1.531 1.479,1.708 0.802,0.177 10 false *a 0.104,0.823 0.354,0.99 0.25,0.167 10 false *b 0.104,1.156 0.427,1.313 0.323,0.156 10 false *c
*a 0.125 sec.
*b ON
*c OFF


Enter the following menus: Chassis / Tire Pressure Monitor / Utility / Signal Check.

HINT:

Every time the test mode (signal check mode) DTC clear conditions are satisfied, the tire pressure warning light illuminates for 1 second. Following this, the tire pressure warning light blinks at 0.125 second intervals.



e.

Press the tire pressure warning reset switch (C2198/98).


f.

Wait for 1.5 minutes with the vehicle stopped, or drive the vehicle at a speed of 50 km/h (31 mph) or more for 1 minute (C2181/81 to C2185/85).

HINT:

The tire pressure warning valve and transmitters send signals to the tire pressure warning ECU and receiver once every 1.5 minutes while the vehicle is stopped and once every minute while driving.



g.

Drive the vehicle at a speed of 20 km/h (12 mph) or more for 3 seconds or more to check the vehicle speed signal (C2191/91).


h.

Check that the tire pressure warning system test mode (signal check mode) DTCs are cleared.

Test Mode (Signal Check Mode) DTC Test Signal Test Mode (Signal Check Mode) DTC Clear Condition
C2181/81 to C2185/85 Transmitter Data Data is received from the relevant transmitter which has a registered ID in the tire pressure warning ECU and receiver.
C2191/91 Vehicle Speed Signal Vehicle speed of 20 km/h (12 mph) or more is detected for 3 seconds or more.
C2198/98 Tire Pressure Warning Reset Switch Signal A signal is received indicating that the tire pressure warning reset switch is pressed.


i.

Result

HINT:

After the signal check is completed, check for test mode (signal check mode) DTCs to confirm the system status.


Condition Procedure
Test mode (signal check mode) DTC is output Repair the faulty part and enter Signal Check again
Test mode (signal check mode) DTCs are cleared No problem


j.

End of test mode (signal check mode)

i.

After completing the test mode (signal check mode), turn the ignition switch off and disconnect the GTS.



k.

Test mode (signal check mode) DTCs

i.

If a trouble code is displayed during the test mode (signal check mode) DTC check, check the diagnosis procedure listed for that code. For details of each code, refer to See page below.

DTC No. Detection Item Link
C2181/81 Transmitter ID1 not Received (Click here)
C2182/82 Transmitter ID2 not Received (Click here)
C2183/83 Transmitter ID3 not Received (Click here)
C2184/84 Transmitter ID4 not Received (Click here)
C2185/85 Transmitter ID5 not Received (Click here)
C2191/91 Vehicle Speed Signal Error (Click here)
C2198/98 Initialization Switch (Click here)