Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM › from 2016.09
RM19Y0E _53 Suspension _059025 TIRE PRESSURE MONITORING _0288381 TIRE PRESSURE WARNING SYSTEM C

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  C2111/11  Transmitter ID1 Operation Stop  C2112/12  Transmitter ID2 Operation Stop  C2113/13  Transmitter ID3 Operation Stop  C2114/14  Transmitter ID4 Operation Stop  C2115/15  Transmitter ID5 Operation Stop  


DESCRIPTION

The tire pressure warning valve and transmitters that are installed in the tire and wheel assemblies measure the tire pressure of each wheel. The measured values are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves. The ECU compares the measured tire pressure values with the tire pressure threshold. When the measured tire pressure value is less than this threshold, the warning light in the combination meter assembly illuminates. The tire pressure warning ECU and receiver stores a DTC when the tire pressure warning valve and transmitter stops transmitting signals. The signals can be forcibly transmitted by releasing the tire pressure rapidly. The stored DTCs are cleared when signal transmission resumes.

DTC No. Detection Item DTC Detection Condition Trouble Area
C2111/11 Transmitter ID1 Operation Stop Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2112/12 Transmitter ID2 Operation Stop Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2113/13 Transmitter ID3 Operation Stop Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2114/14 Transmitter ID4 Operation Stop Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver


C2115/15 Transmitter ID5 Operation Stop Tire pressure warning valve and transmitters stop transmitting signals
·

Tire pressure warning valve and transmitter

·

Tire pressure warning ECU and receiver



HINT:

It is necessary to perform the following procedure to identify the tire pressure warning valve and transmitter that is malfunctioning because it cannot be identified by the output DTC.


WIRING DIAGRAM

C364608E01
0.563,0.896 1.948,1.76 1.385,0.865 10 false Tire Pressure Warning Valve and Transmitter 0.563,1.969 1.927,2.74 1.365,0.771 10 false Tire Pressure Warning Valve and Transmitter 3.052,0.365 4.438,1.229 1.385,0.865 10 false Tire Pressure Warning Valve and Transmitter 3.073,1.427 4.458,2.292 1.385,0.865 10 false Tire Pressure Warning Valve and Transmitter 3.073,2.49 4.458,3.354 1.385,0.865 10 false Tire Pressure Warning Valve and Transmitter 0.167,4.313 2.354,4.75 2.188,0.438 10 false Skid Control ECU (Brake Actuator Assembly) 0.188,4.135 0.573,4.448 0.385,0.313 10 false A13 0.844,4.958 1.927,5.302 1.083,0.344 10 false from IG Circuit 3.625,5.125 4.063,5.417 0.438,0.292 10 false IG1 3.198,4.469 5.385,4.906 2.188,0.438 10 false Combination Meter Assembly 3.198,4.302 3.635,4.594 0.438,0.292 10 false E34 5.531,3.49 6.219,3.792 0.688,0.302 10 false SPEED 4.385,3.49 5.01,3.823 0.625,0.333 10 false SPDO 4.521,3.979 5,4.281 0.479,0.302 10 false IND 5.542,3.979 6.167,4.313 0.625,0.333 10 false IND 4.875,3.375 5.25,3.677 0.375,0.302 10 false 10 4.885,3.865 5.365,4.167 0.479,0.302 10 false 34 5.542,4.969 5.979,5.26 0.438,0.292 10 false IG1 3.542,6.896 4.083,7.333 0.542,0.438 10 false DLC3 3.167,6.885 3.708,7.323 0.542,0.438 10 false E12 3.781,5.823 4.323,6.26 0.542,0.438 10 false ECUT 3.188,6.469 3.729,6.906 0.542,0.438 10 false E 3.24,3.333 3.719,3.635 0.479,0.302 10 false 9 1.563,3.5 2,3.75 0.438,0.25 10 false CANH 3.438,3.969 4.01,4.292 0.573,0.323 10 false CANL 3.438,3.49 4.01,3.823 0.573,0.333 10 false CANH 1.563,3.979 2.135,4.302 0.573,0.323 10 false CANL 3.229,3.802 3.708,4.104 0.479,0.302 10 false 8 2.042,3.802 2.521,4.104 0.479,0.302 10 false 10 2.052,3.333 2.531,3.635 0.479,0.302 10 false 22 5.313,3.865 5.792,4.167 0.479,0.302 10 false 5 5.313,3.375 5.583,3.698 0.271,0.323 10 false 2 5.302,4.844 5.781,5.146 0.479,0.302 10 false 1 5.542,5.813 5.979,6.104 0.438,0.292 10 false Tc 5.531,6.479 6.073,6.854 0.542,0.375 10 false SIL 5.531,7.917 6.073,8.229 0.542,0.313 10 false CLSW 2.99,7.781 3.469,8.083 0.479,0.302 10 false 1 3.177,7.802 3.656,8.104 0.479,0.302 10 false CL- 3.906,7.792 4.385,8.094 0.479,0.302 10 false CL+ 4.292,7.781 4.771,8.083 0.479,0.302 10 false 4 5.396,9.021 5.875,9.323 0.479,0.302 10 false K6 3.906,6.469 4.448,6.844 0.542,0.375 10 false SIO 5.24,6.323 5.719,6.625 0.479,0.302 10 false 10 4.26,6.333 4.74,6.635 0.479,0.302 10 false 7 5.313,5.698 5.792,6 0.479,0.302 10 false 3 2.979,6.323 3.458,6.625 0.479,0.302 10 false 4 4.25,5.708 4.729,6.01 0.479,0.302 10 false 13 5.302,7.781 5.781,8.083 0.479,0.302 10 false 7 5.552,8.302 6.094,8.677 0.542,0.375 10 false GND 5.542,8.677 6.083,9.052 0.542,0.375 10 false GND3 5.25,8.188 5.729,8.49 0.479,0.302 10 false 12 5.323,8.583 5.802,8.885 0.479,0.302 10 false 9 3.021,8.302 3.563,8.74 0.542,0.438 10 false E96 3.031,8.458 4.417,9.01 1.385,0.552 10 false Tire Pressure Warning Reset Switch 5.396,9.188 6.781,9.74 1.385,0.552 10 false Tire Pressure Warning ECU and Receiver 0.76,9.042 1.938,9.354 1.177,0.313 10 false : Radio Waves 0.771,9.417 2.719,9.802 1.948,0.385 10 false : CAN Communication Line

PROCEDURE

1.PERFORM FORCED TRANSMISSION OF TRANSMITTER ID OF ALL WHEELS
a.

Set the tire pressure to the specified value.

Click hereSuspension>TIRE / WHEEL>TIRE AND WHEEL SYSTEM>INSPECTION


b.

Turn the ignition switch off.


c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch ON.


e.

Turn the GTS on.


f.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


g.

Check the values by referring to the table below.

Chassis > Tire Pressure Monitor > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
ID1 Tire Inflation Pressure ID1 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1
ID2 Tire Inflation Pressure ID2 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed,data has not been received.*1
ID3 Tire Inflation Pressure ID3 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed,data has not been received.*1
ID4 Tire Inflation Pressure ID4 tire inflation pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) /380 kPa (3.9 kgf/cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed,data has not been received.*1
ID5 Tire Inflation Pressure ID5 tire Inflation Pressure min.: Absolute pressure (abs) / 0 kPa (0 kgf/cm2, 0 psi), Relative pressure (Gauge) / 0 kPa (0 kgf/cm2, 0 psi)
max.: Absolute pressure (abs) / 480 kPa (4.9 kgf/cm2, 70 psi), Relative pressure (Gauge) / 380 kPa (3.9 kgf/ cm2, 55 psi)
Actual tire inflation pressure If N/A is displayed, data has not been received.*1

HINT:

*1: It may take a few minutes until the values are displayed. If the values are not displayed after a few minutes, perform troubleshooting according to the inspection procedure for DTCs C2121/21 to C2125/25.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21



h.

Rapidly reduce the tire pressure for each wheel at least 40 kPa (0.4 kgf/cm2, 5.8 psi) within 30 seconds.

i.

Check that each "ID Tire Inflation Pressure" value displayed on the GTS has changed.

OK:

Each "ID Tire Inflation Pressure" value displayed on the GTS changed to the actual tire inflation pressure value.


NOTICE:
·

It may take a few minutes until the values are displayed.

·

When an "ID Tire Inflation Pressure" value has not changed, reset the tire pressure to the appropriate specified value and rotate the tire 90 to 270 degrees. Then rapidly release the tire pressure and recheck the value.

·

The wheel position cannot be determined from ID1 through ID5 on the Data List.




ii.

After confirming that all of the tire "ID Tire Inflation Pressure" values displayed on the GTS have changed, set the tire pressure to the appropriate specified values.

HINT:

If an "ID Tire Inflation Pressure" value displayed on the GTS has not changed after rechecking, inspect for another problem.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>C2121/21




Result:
Proceed to
OK
NG



OK

END

NG

GO TO TRANSMITTER AND RECEIVER INSPECTION PROCEDURE