Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR(w/ VSC) › from 2016.09
RM19Y0E _54 Brake _002992 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0288383 BRAKE ACTUATOR(w/ VSC) A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR(w/ VSC)  INSTALLATION  


PROCEDURE

Hide 44547B 1.INSTALL BRAKE ACTUATOR BRACKET CUSHION

a.

Install the 3 brake actuator bracket cushions.


Hide 44547C 2.INSTALL BRAKE ACTUATOR BRACKET SPACER

a.

Install the 3 brake actuator bracket spacers.


Hide 44510 3.INSTALL BRAKE ACTUATOR ASSEMBLY

a.

Install the brake actuator assembly to the brake actuator bracket assembly with the 3 bolts.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


Hide 4.INSTALL BRAKE ACTUATOR WITH BRACKET

a.

Install the brake actuator with bracket with the 3 bolts.

Torque:
19.5 N*m (199 kgf*cm, 14 ft.*lbf)


b.
C363892C01
1.854,2.885 2.167,3.042 0.313,0.156 10 false *a
*a Torque Wrench Fulcrum Length
V100135

10 mm Flare Nut
V100136

12 mm Flare Nut


Using a union nut wrench, install each brake line into the correct position of the brake actuator assembly.

Torque:
Specified tightening torque (for 10 mm Flare Nut) : 15.2 N*m (155 kgf*cm, 11 ft.*lbf)
Specified tightening torque (for 12 mm Flare Nut) : 19.6 N*m (200 kgf*cm, 14 ft.*lbf)

HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

10 mm Flare Nut: When using a union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)):

13.4 N*m (137 kgf*cm, 10 ft.*lbf)

·

12 mm Flare Nut: When using a union nut wrench (fulcrum length of 20 mm (0.7874 in.)) + torque wrench (fulcrum length of 162 mm (6.3779 in.)):

17.4 N*m (177 kgf*cm, 13 ft.*lbf)




c.
C333886

Connect the connector and lock the lock lever as shown in the illustration.

NOTICE:

Make sure that the connector is locked securely.



Hide 5. FILL RESERVOIR WITH BRAKE FLUID

Hide 47201 6.BLEED MASTER CYLINDER

Hide 7.BLEED CLUTCH LINE (for 2NR-VE with Manual Transmission)

Hide 9. CHECK FLUID LEVEL IN RESERVOIR

Hide 10.INSPECT FOR BRAKE FLUID LEAK