Home › Drivetrain › P610 (HYBRID TRANSMISSION / TRANSAXLE) › MOTOR CABLE
RM32K0E _52 Drivetrain _059722 P610 HYBRID TRANSMISSION / TRANSAXLE _0292761 MOTOR CABLE A

P610 HYBRID TRANSMISSION / TRANSAXLE  MOTOR CABLE  INSTALLATION  


PROCEDURE

Hide G1148 1.INSTALL MOTOR CABLE

CAUTION:

Be sure to wear insulated gloves.


a.

Using an insulated tool, install the motor cable to the hybrid vehicle transaxle assembly with the 6 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

NOTICE:
·

Keep the motor cable terminals and their installation area free from foreign matter, water, etc.

·

Do not touch the waterproof seal or terminals of the motor cable.




b.

Engage the 2 claws to install a new terminal cap to the hybrid vehicle transaxle assembly.

NOTICE:
·

Keep the terminal cap and its installation area free from foreign matter, water, etc.

·

Do not pinch the O-ring.

·

Check that the terminal cap is securely installed.




c.

Temporarily install the connector cover to the hybrid vehicle transaxle assembly with the 2 bolts.


d.

Tighten the 2 bolts to install the connector cover.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


Hide G9200 2.INSTALL INVERTER WITH CONVERTER ASSEMBLY