Home › Engine / Hybrid System › 2ZR-FXE (ENGINE MECHANICAL) › FRONT CRANKSHAFT OIL SEAL
RM32K0E _51 Engine / Hybrid System _059913 2ZR-FXE ENGINE MECHANICAL _0293920 FRONT CRANKSHAFT OIL SEAL A

2ZR-FXE ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 1.REMOVE FRONT WHEEL RH

Hide 51441 2.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443C 3.REMOVE REAR ENGINE UNDER COVER RH

Hide 51107A 4.REMOVE REAR SIDE RAIL REINFORCEMENT SUB-ASSEMBLY RH

Hide 13471 5.REMOVE CRANKSHAFT PULLEY

a.
A372539C01
0.521,1.938 0.646,1.938 0.646,1.938 0.76,2.115 false 1.396,1.667 1.885,1.271 1.885,1.271 1.625,1.813 true 0.344,1.833 0.656,2.031 0.313,0.198 10 false *a 1.865,1.021 2.323,1.219 0.458,0.198 10 true SST 1.583,3.188 1.896,3.385 0.313,0.198 10 false *b
*a Hold
*b Turn


Using SST to hold the crankshaft pulley, loosen the crankshaft pulley set bolt. Further loosen the crankshaft pulley set bolt until 2 or 3 threads remain screwed into the crankshaft.

SST
09213-58014  (91551-80840)
09330-00021  


b.
A372540C01
0.542,2.76 0.656,2.76 0.656,2.76 0.958,2.344 false 0.25,2.667 0.708,2.865 0.458,0.198 10 false SST 0.219,1.854 0.531,2.052 0.313,0.198 10 false *a 0.771,3.115 1.083,3.313 0.313,0.198 10 false *b
*a Hold
*b Turn


Using SST and the crankshaft pulley set bolt, remove the crankshaft pulley and crankshaft pulley set bolt.

SST
09950-50013  (09951-05010, 09952-05010, 09953-05020, 09954-05021)

HINT:

Apply lubricant to the threads and end of SST.



Hide 11302A 6.REMOVE TIMING CHAIN COVER OIL SEAL

a.
A372541C01
1.406,1.292 1.646,1.74 1.646,1.74 1.771,1.74 false 2.208,2.542 2.708,2.938 2.708,2.938 3.146,2.542 false 1.833,1.667 2.146,1.865 0.313,0.198 10 false *b 2.656,3 2.969,3.198 0.313,0.198 10 false *a
*a Cut Position
*b Protective Tape


Using a knife, cut through the lip of the timing chain cover oil seal.


b.

Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain cover oil seal.

NOTICE:

After removal, check the crankshaft for damage. If it is damaged, smooth the surface with 400-grit sandpaper.