The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition using 2 circuits (GL1, GL2).
If the identification ID of the yaw rate and acceleration sensor (airbag sensor assembly) is different to that stored in the skid control ECU (brake booster with master cylinder assembly), DTC C1240 is stored.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1240 | Yaw Rate Sensor discrimination | 406 | The identification ID sent from the yaw rate sensor is different to that stored in the skid control ECU (brake booster with master cylinder assembly) for 1 second or more. | ·
Incorrect yaw rate sensor (airbag sensor assembly) installed ·
Skid control ECU (brake booster with master cylinder assembly) |
VSC DTC |
After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration after clearing previously calibrated data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION
Check that the proper yaw rate and acceleration sensor (airbag sensor assembly) is installed.
Proper yaw rate and acceleration sensor (airbag sensor assembly) is installed.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Clear the DTCs.
Turn the power switch off.
Turn the power switch on (IG).
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTC C1240 is output. (for LHD) | A |
| DTC C1240 is output. (for RHD) | B |
| DTC C1240 is not output. | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING