The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the airbag sensor assembly removal/installation are shown below.
*1: When performing learning using the GTS.
Use the same procedure for RHD and LHD vehicles.
The following procedure is for LHD vehicles.
1. PRECAUTION
Be sure to read Precaution thoroughly before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
Click hereGeneral>MAINTENANCE>2ZR-FXE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
3.REMOVE REAR CONSOLE BOX ASSEMBLY
87212F
4.REMOVE REAR NO. 2 AIR DUCT (w/ Rear Air Duct)
|
Remove in this direction (1) |
|
Remove in this direction (2) |
Disengage the claws to remove the rear No. 2 air duct as shown in the illustration.
89170
5.REMOVE AIRBAG SENSOR ASSEMBLY
Check that the power switch off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Remove the clip and turn back the front floor carpet assembly as shown in the illustration (for LH side).
Remove the clip and turn back the front floor carpet assembly as shown in the illustration (for RH side).
|
Release in this direction |
Disconnect the connectors from the airbag sensor assembly as shown in the illustration.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Remove the 3 bolts and airbag sensor assembly.