The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition using 2 circuits (GL1, GL2).
The skid control ECU (brake booster with master cylinder assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system.
| DTC No. | Detection Item | INF Code | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|---|
| C1442 | Invalid Data Received from Deceleration Sensor | 572 | When voltage at terminal IG1 is 9.54 V or more, sensor invalid information received from acceleration sensor is ON continuously for 10 seconds or more. | ·
Acceleration sensor (airbag sensor assembly) ·
Acceleration sensor (airbag sensor assembly) installed improperly |
ABS DTC |
| C1443 | Invalid Data Received from Yaw Rate Sensor | 715 | When voltage at terminal IG1 is 9.54 V or more, sensor invalid information received from yaw rate sensor is ON continuously for 10 seconds or more. | ·
Yaw rate sensor (airbag sensor assembly) ·
Yaw rate sensor (airbag sensor assembly) installed improperly |
VSC DTC |
After replacing or reinstalling the yaw rate and acceleration sensor (airbag sensor assembly), perform yaw rate and acceleration sensor zero point calibration after clearing previously calibrated data.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION
Clear the DTCs.
Turn the power switch off.
Turn the power switch on (IG).
Check if the same DTC is output.
| Result | Proceed to |
|---|---|
| DTCs C1442 and C1443 are not output. | A |
| DTCs C1442 and/or C1443 are output. | B |
A
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
B