The parking brake ECU assembly receives vehicle tilt angle information from the deceleration sensor (airbag sensor assembly) via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C1245/62 | Deceleration Sensor | One of following conditions is met:
1.
An error signal is sent from deceleration sensor (airbag sensor assembly) for approximately 0.3 seconds. 2.
While the deceleration sensor (airbag sensor assembly) signal is judged to be stuck, starting off and stopping of vehicle occurs 16 times. 3.
Comparison error between deceleration sensor (airbag sensor assembly) 1 and deceleration sensor (airbag sensor assembly) 2 output values occurs for 60 seconds or more. |
Deceleration sensor (Airbag sensor assembly) | DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
| Vehicle Condition | ||||
|---|---|---|---|---|
| Pattern 1 | Pattern 2 | Pattern 3 | ||
| Diagnosis Condition | Power switch on (IG) | ○ | ○ | ○ |
| Malfunction Status | An error signal is sent from the deceleration sensor (airbag sensor assembly) | ○ | - | - |
| While the deceleration sensor (airbag sensor assembly) signal is judged to be stuck, starting off and stopping the vehicle occurs 16 times | - | ○ | - | |
| Comparison error between deceleration sensor (airbag sensor assembly) 1 and deceleration sensor (airbag sensor assembly) 2 output values occurs | - | - | ○ | |
| Detection Time | Approximately 0.3 seconds | - | 60 seconds or more | |
| Number of Trips | 1 trip | 1 trip | 1 trip | |
DTC will be output when conditions for either of the patterns in the table above are met.
When replacing the deceleration sensor (airbag sensor assembly), perform initialization and calibration of the linear solenoid valve.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Clear the DTCs.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>DTC CHECK / CLEAR
Turn the power switch off.
Check for DTCs.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING