| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13AE/72 | System information not Received | Both of following conditions are met:
1.
Power switch on (IG) 2.
When power switch is first turned on (IG) after parking brake ECU assembly has been replaced, system cannot communicate with hybrid vehicle control ECU for approximately 4 seconds |
·
Hybrid vehicle control ECU ·
CAN communication system ·
Parking brake ECU assembly |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
When replacing the parking brake ECU assembly, operate the electric parking brake switch (electric parking brake switch assembly) as the parking brake indicator light blinks (red) when the power switch is first turned on (IG).
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Check for DTC.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC C13AE/72 and a CAN DTC are output at the same time | A |
| DTC C13AE/72 is output and the MIL is illuminated | B |
| Only DTC C13AE/72 is output | C |
| DTCs are not output | D |
A
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
B
C
D
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING