Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE ECU › 2016.10–2018.05
RM32K0E _54 Brake _060048 PARKING BRAKE _0297946 ELECTRIC PARKING BRAKE ECU A

PARKING BRAKE  ELECTRIC PARKING BRAKE ECU  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the parking brake ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control) (Click here)
Simple intelligent parking assist system*1
Toyota parking assist-sensor system*1
Pre-collision system
Initialize back door lock Power door lock control system (Click here)
Parking brake ECU assembly Operate the electric parking brake switch Parking brake indicator light (red) blinks when the power switch is first turned on (IG) (Click here)

*1: When performing learning using the GTS.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>SIMPLE INTELLIGENT PARKING ASSIST SYSTEM>CALIBRATION

PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

Be sure to read Precaution thoroughly before servicing.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SYSTEM>PRECAUTION

·

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Click herePower Source / Network>2ZR-FXE (BATTERY / CHARGING)>AUXILIARY BATTERY>REMOVAL

NOTICE:

When disconnecting the cable from the auxiliary negative (-) auxiliary battery terminal, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64740C 3.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

HINT:

Use the same procedure as for the RH side.

Click hereVehicle Interior>SEAT BELT>REAR SEAT OUTER BELT ASSEMBLY>REMOVAL


Hide 89050 4.REMOVE PARKING BRAKE ECU ASSEMBLY

a.
C368003

Disconnect the 2 parking brake ECU assembly connectors.


b.

Remove the 2 nuts and parking brake ECU assembly.